
LEON3FT-RTAX
functionality
In addition to the LEON3FT core, the LEON3FT-RTAX includes a
number of application-specific IP cores. Three pre-define
configurations are available to address different application
requirements. All configurations have the same basic
architecture, which includes the following functions:
- LEON3FT processor with 2*8
Kbyte cache
- LEON3 Debug Support Unit with
JTAG debug interface
- PROM/SRAM controller with EDAC
- Interrupt controller for 15 interrupts
- Timer module with two 32-bit timers and watchdog
- Two UARTs with 16 byte FIFO
- 16-bit I/O port
- Power-down mode
The four configuration are differentiated according to the
following table:
|
Configuration |
IEE-754-FPU |
SDRAM Ctrl |
Spacewire I/F |
1553 I/F |
CAN 2.0 IF |
| LEON3FT-RTAX-IC |
YES |
- |
1 |
1 RT |
1 |
| LEON3FT-RTAX-EU |
YES |
YES |
2 |
- |
- |
| LEON3FT-RTAX-US |
YES |
- |
- |
2 BRM |
- |
| LEON3FT-RTAX-MI |
- |
YES |
1 |
|
2 |
Performance and power
All configuration can be clocked at 24 MHz
over the full military temperature range. This provides 20 DMIPS and 4
MFLOPS in configurations with an FPU. The power consumption depends on
the application, and is typically 0.5 W at full processor load. In
power-down mode, the processor power consumption is ~ 0.3 W.
Custom configurations
In addition to the pre-defined configurations,
it is possible to order LEON3FT-RTAX devices with custom configurations.
Such configuration can also include IP core from the GRLIB IP library
which are not listed above. An NRE cost will be charged for the
development of each custom configuration.
Packaging, quality and lead time
The LEON3FT-RTAX devices are shipped as
pre-programmed and tested parts in all quality levels supported by Actel.
Supported packages are CQFP352 and CCGA624
Price :
(Please include the quantity)
|